Stop Guessing. Start Fitting With Real Swing Data.
BirdieFit Lab replaces the "feels right" fitting chart with a launch monitor, an honest fitter, and an in-house build shop. We measure your actual swing, not an average golfer's swing, and build every club to match what the numbers say.
Real Gains, Not Just Better-Feeling Clubs
Off-the-rack sets are built for a golfer who doesn't exist. Your swing speed, tempo, and angle of attack are yours alone — and a couple degrees of lie angle or the wrong shaft flex can quietly cost you accuracy and distance every single round.
We pair a Doppler-radar launch monitor with a full demo fleet across major manufacturers and an in-house build shop, so the clubs you leave with are cut, built, and playable — usually inside a week.
- Independent fitters — we're not tied to a single brand's quota
- Data from every swing, not just your best three
- In-house build shop for same-week turnaround
- Fitting fee credited toward any club purchase
| Club | Carry | Gap |
|---|---|---|
| 7-Iron | 158 yds | — |
| 8-Iron | 147 yds | 11 yds |
| 9-Iron | 135 yds | 12 yds |
| PW | 121 yds | 14 yds |
| GW (50°) | 106 yds | 15 yds |
One Bag, Six Fittings, Zero Guesswork
Every session starts with the clubs already in your bag, your swing data, and a straightforward conversation about where you're leaving distance or accuracy on the table.
Driver Fitting
Dial in launch angle, spin, and shaft profile to unlock distance and start-line consistency off the tee.
Learn more →Iron Fitting
Match lie, loft, length, and shaft flex across the set for tighter dispersion and better gapping.
Learn more →Wedge Fitting
Bounce, grind, and loft gapping tuned to your turf conditions and the shots you actually hit.
Learn more →Fairway Wood Fitting
Confidence off the deck and from the tee with heads and shafts built for your attack angle.
Learn more →Hybrid Fitting
Fill the long-iron gap with a hybrid that launches high and lands soft, matched to your set makeup.
Learn more →Putter Fitting
Length, lie, loft, and face balance measured against your stroke path and setup, not a chart.
Learn more →Four Steps From First Swing to New Clubs
Interview & Goals
We start with your bag, your misses, and what you want the new clubs to fix.
Launch Monitor Session
Hit real shots with your current clubs and demo heads while we capture every data point.
Spec Recommendation
We walk through head, shaft, length, and lie/loft options backed by your own numbers.
Build & Verify
Clubs are built in-house and checked on our frequency machine before pickup.
What Golfers Say After Their Fitting
My driver fitting added 11 yards of carry and cut my miss in half. The data made the shaft decision obvious — no upsell, just numbers.
I'd never been iron fit before. The lie angle on my old set was 3° flat and I didn't even know it. Ball flight is night and day now.
Full bag rebuild from a fitter who actually listened. Gapping is clean 1-through-wedge for the first time in my life.
Ready to See Your Own Numbers?
Sessions run 60–90 minutes and include a full written report. Fitting fees are credited toward any club purchase built in our shop.